User guide

Bands
14-13
Fig. 14-8. Creating a band in lines mode.
In lines mode, no intensity trace will pop up when you click on the image.
Note: After identifying several bands, be sure to renumber the bands in your
image by selecting Sort and Recalculate from the Edit menu.
14.3.b Adjusting Bands
After you identify the bands on your image—either automatically or
manually—you may want to go back and change the placement of the band
boundaries.
To reposition a band’s boundaries, select Adjust Band from the menu or
toolbar.
If you are in brackets mode, click and drag the upper or lower bracket of the
band that you want to adjust. If you are in lines mode, click and drag near the
upper or lower boundary of the band that you want to adjust.
When you click and drag the mouse, a pop-up lane trace will appear. The
band being adjusted will be highlighted, and lines extending from the band
boundaries on the image to the corresponding boundaries on the intensity
trace will appear.
Drag the band boundary to the desired location, then release the mouse
button.