Unit installation

Chapter 4 Configuration Installation and Operation Manual
4-14 FCD-E1 Supervision Language FCD-E1
Table 4-3. Mnemonic Command Set Index (Cont.)
Mnemonic Purpose Explicit Command Format
MT Set the time of the FCD-E1 internal clock TIME
MX End the current control session EXIT
MY Exit telnet session BYE
SA Display the alarm buffer contents DSP ALM
SB Display the BER test results submenu, for orientation in using
the mnemonic commands
–
SB1 Display the results of the last BER measurement on channel 1 DSP BERT CH1
SB2 Display the results of the last BER measurement on channel 2 DSP BERT CH 2
SBS Display the results of the last BER measurement on sublink DSP BERT SL
SE Display agent DSP Agent
SF Display the FDL commands submenu –
SFM Display the last FDL message received by the FCD-E1 main link DSP FDL ML
SFS Display the last FDL message received by the FCD-E1 sublink DSP FDL SL
SG Display information on the remote SNMP agents handled by the
FCD-E1 IP router
DSP REM AGENT
SH Display the results of the last periodical hardware self-test DSP HDR TST
SP Display the performance display commands submenu, for
orientation in using the mnemonic commands
–
SPM Display the contents of the main link performance monitoring
registers, and optionally clear these registers
DSP PM ML
SPS Display the contents of the sublink performance monitoring
registers, and optionally clear these registers
DSP PM SL
SS Display the status display commands submenu, for orientation
in using the mnemonic commands
–
SS1 Display status information on channel 1 DSP ST CH1
SS2 Display status information on channel 2 DSP ST CH2
SSM Display status information on the main link DSP ST ML
SSS Display status information on the sublink DSP ST SL
SSY Display system status DSP ST SYS
ST Display information on the use and type of main link time slots DSP TS