Unit installation

Chapter 4 Configuration Installation and Operation Manual
4-10 FCD-E1 Supervision Language FCD-E1
Table 4-2. Explicit Command Set Index (Cont.)
Command Purpose Options Mnemonic
DSP FDL ML Display the last FDL message received by the FCD-E1 main
link
/R SFM
DSP FDL SL Display the last FDL message received by the FCD-E1
sublink
/R SFS
DSP HDR TST Display the results of the last hardware self-test SH
DSP PM ML Display the contents of the main link performance
monitoring registers, and optionally clear these registers
/C
/CA
SPM
DSP PM SL Display the contents of the sublink performance
monitoring registers, and optionally clear these registers
/C
/CA
SPS
DSP REM AGENT Display information on the remote SNMP agents handled
by the FCD-E1 IP router
SG
DSP ST CH1
DSP ST CH2
Display status information on the corresponding channel SS1
SS2
DSP ST ML Display status information on the main link SSM
DSP ST SL Display status information on the sublink SSS
DSP ST SYS Display system status SSY
DSP TS Display information on the use and type of main link time
slots
ST
F Define control codes for the supervision terminal MF
EXIT End the current control session MX
HELP Displays a concise index of commands and option switches MH
INIT DB Load the default configuration instead of the user’s
configuration.
ID
LP LOC ANA ML
LP REM ANA ML
LP LOC DIG ML
LP REM DIG ML
LP LOC ANA SL
LP REM ANA SL
LP LOC DIG SL
LP REM DIG SL
LP LOC CH1 (CH2)
LP REM CH1 (CH2)
LP BERT CH1 (CH2)
LP BERT SL
LP INBAND SL
LP INBAND CH1 (CH2)
Activate a user-controlled test or loopback LLAM
LRAM
LLDM
LRDM
LLAS
LRAS
LLDS
LRDS
LL1 (LL2)
LR1 (LR2)
LB1 (LB2)
LBS
LIS
LI1 (LI2)
PASSWORD= Enter the user password at the start of a new session;
followed by the password itself
MP
RESET Perform a reset of the FCD-E1 –
TIME Set the time of the FCD-E1 internal clock MT