Unit installation

Installation and Operation Manual Chapter 4 Configuration
FCD-E1 FCD-E1 Supervision Language 4-7
Configuration of Telnet or SNMP Management
To prepare the FCD-E1 system for configuration by means of Telnet hosts and/or
SNMP management stations, use the supervision terminal to configure the
supervisory port and the SNMP agent as explained below.
SNMP Agent Configuration
• Define the FCD-E1 system name, using the DEF NAME command.
• Define the SNMP agent parameters using the
DEF AGENT command. The IP
address and the subnet mask, as well as the various community names must
match those of the IP host. A typical SNMP agent parameters data form is
shown below:
TELNET_APATHY_TIME
10 MIN
IP_ADDRESS :XXX.XXX.XXX.XXX
MAC ADDRESS :XXX.XXX.XXX.XXX.XXX.XXXX
READ COMMUNITY :public
WRITE COMMUNITY :private
TRAP COMMUNITY IS : public
where X stands for the digits of the IP and MAC addresses.
Configuration of FCD-E1 Ports for Telnet and SNMP Access
To use a FCD-E1 serial port for Telnet and SNMP access, use the DEF SP command
and select the following parameters:
• Select the appropriate data rate in the
SPEED field. Do not select AUTO.
• Select
NMS-SLIP in the AUXILIARY DEVICE field.
At this stage, you can start using Telnet hosts or SNMP management stations to
perform FCD-E1 configuration activities.
4.4 FCD-E1 Supervision Language
This section presents the set of commands available for the FCD-E1 supervision
terminal.
For a detailed description of the FCD-E1 command set, refer to Appendix D.
The FCD-E1 operating mode, and all of its functions, is controlled by a set of
configuration parameters. The user, in accordance with the requirements of the
specific applications can determine these parameters.
The preparation of the desired set of configuration parameters is made in
accordance with a set of rules, which together form the FCD-E1 supervision
language. The supervision language is used to communicate with the central
control subsystem of the FCD-E1, using a supervision terminal physically
connected to the supervisory port, CONTROL DCE. Telnet hosts can also use the
same language.