Unit installation

Chapter 4 Configuration Installation and Operation Manual
4-6 Preliminary Configuration FCD-E1
For detailed instructions regarding the use of the FCD-E1 command line interface,
refer to the Using the Explicit Command Mode on page 4-15.
Loading of Default Parameters
To load the default parameters, enter the INIT DB command.
Selecting the Supervisory Terminal Control Sequences
Select the terminal control sequences for the terminal type in use by entering the
command
DEF TERM 'terminal_type'. 'terminal_type' stands for one of
the following types: VT52, VT100, TV920, FREEDOM100, FREEDOM220.
In case your terminal requires control sequences differing from those used by the
terminals listed above, type the command F and enter your terminal control
sequences.
Configuration of Terminals
To prepare the FCD-E1 system for configuration by means of a supervision
terminal, perform the activities described below.
Even in case you will manage the FCD-E1 system using only Telnet hosts and/or
SNMP management stations, first you must use the supervision terminal to
configure the supervisory port and the SNMP agent.
CONTROL DCE Port Configuration
Configure the CONTROL DCE port of the FCD-E1 system by entering the
command
DEF SP. You will see the supervisory port configuration data form. A
typical form with the default values is shown below:
SPEED DATA PARITY INTERFACE CTS DCD_DEL
DSR
9600 8 NO DCE =RTS 0_MSEC
ON
POP_ALM PWD LOG_OFF AUXILIARY_DEVICE
NO NO NO TERMINAL
Setting the Time and Date for the Internal Clock
Set the time of the internal clock of the FCD-E1 system by entering the command
TIME, and then set the date by entering the command DATE.
At this stage, you can start using the supervision terminal to perform FCD-E1
configuration activities.
Activating Password Protection
To prevent unauthorized modification of the FCD-E1 system parameters, you can use
a password. Set the password by setting PWD in DEF SP to ‘yes’ and then entering
the command
DEF PWD.