Unit installation

FCD-E1 Controls and Indicators 3-1
Chapter 3
Operation
3.1 Turning FCD-E1 On
To turn FCD-E1 on, set the rear POWER switch to ON (AC version) or connect it
to the power supply (DC version). Upon turn-on, FCD-E1 performs self-test:
observe the front-panel indications.
During the self-test, FCD-E1 displays the software version in the format X.YZ:
FCD REV X.YZ
SELF TEST
After successfully completing the self-test procedure, FCD-E1 switches to the
default ALARM BUFFER screen. If FCD-E1 fails the self-test, you will see SELF TEST
FAILED in the second row. In this case, FCD-E1 must be repaired before it can be
used again.
Access to the inside of the unit is permitted only to qualified and authorized
personnel.
3.2 Controls and Indicators
Table 3-1 lists the functions of the FCD-E1 controls, connectors and indicators,
located on the FCD-E1 front panel. The index numbers in Table 3-1 correspond to
the item numbers in Figure 3-1.
1 4
8 9 10 115 6
2 3
7
Figure 3-1. FCD-E1 Front Panel
Warning