Unit installation

Chapter 2 Installation and Setup Installation and Operation Manual
2-14 Connecting the Cables FCD-E1
3. Identify the front and rear of the top cover, and position the cover on the
lower half of the FCD-E1, so that the cover guides are located just above the
holes in the lower half. Close the cover and ensure that the protruding tips of
the cover guides enter the corresponding recesses in the lower half.
4. Hold the cover in place, and turn the assembly over, to gain access to the
bottom of the unit.
5. Insert the original cover screws in their positions and tighten carefully. Do not
use excessive torque.
2.6 Connecting the Cables
The connectors located on the rear panels of FCD-E1 depend on the equipment
version (see the FCD-E1 data sheet for a complete list of ordering options).
Figure 2-6 shows a typical rear panel of an FCD-E1 unit with a single RS-530
interface data channel, and identifies connector locations.
Figure 2-7 shows a typical rear panel of an FCD-E1 unit with a sublink and 2 data
channels. Note the additional connectors of the sublink.
Figure 2-8 shows a typical rear panel of an FCD-E1 unit with a sublink and an
additional Ethernet port. The Ethernet interface has a shielded RJ-45 connector.
AC Fuse Power Switch
AC Power
Connector
Control DTE
Connector
User Channel
No. 1
Connector
Balanced
Interface
Connector
Unbalanced
Receive Input
Unbalanced
Transmit
Output
Main Link Interface
Figure 2-6. FCD-E1 with a Single Data Channel