Unit installation

Chapter 1 Introduction Installation and Operation Manual
1-30 Technical Specifications FCD-E1
Diagnostics
Test Loops
• E1 main link local analog loopback, towards the local
DTE
• E1 main link local digital loopback, towards the local
DTE
• E1 main link remote analog loopback, towards the
remote DTE
• Channel loopback, towards the remote DTE
• Channel loopback, towards the local DTE
• E1 sublink remote digital loopback, towards the
remote DTE
• E1 sublink local analog loopback, towards the local
DTE
• E1 sublink remote analog loopback, towards the
remote DTE
• BER test for each data port individually
• Inband code-activated loopback per data port
Note
No loopback can be activated for the Ethernet interfaces.
Statistics
• Per ITU-T Rec. G.706 when CRC-4 is enabled
• OOS and BPV statistics without CRC-4
Supervisory
Ports
Inband Management
SNMP and Telnet supported inband, using the S
a
bits or a
dedicated timeslot (Frame Relay or proprietary protocol)
Out-of-Band Ports
• Front-panel CONTROL DCE port
• Rear-panel CONTROL DTE port
CONTROL DCE
Functions
Full control over FCD-E1 operation using supervision
(“dumb”) terminal, SNMP (SLIP), or Telnet (SLIP),
dial-out, dial-in using a modem
CONTROL DTE
Functions
Dial-out only
Port interfaces
V.24/RS-232 (asynchronous)
Port connectors
9-pin D-type female
Data rates
CONTROL DCE
port
300, 1200, 2400, 4800, 9600, or 19200 bps, with
automatic detection of data rate (Autobaud)
CONTROL DTE
port
300, 1200, 2400, 4800, or 9600, without Autobaud
Data word format
• One start bit
• 7 or 8 data bits
• Even, odd, or no parity
• One stop bit