Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-41
Use
The use and the display format are similar to the DSP ST ML command.
DSP ST SYS
Purpose
Display system status information.
Syntax
DSP ST SYS
Use
To view the system status, type:
DSP ST SYS<Enter>
A typical system status display is shown below.
NODE = ‘node number’
NAME = ‘FCD-E1 name’
NODAL CLOCK = INT
SOFTWARE VER = X.Y
HARDWARE VER = Z.V
FCD TYPE = E1/X/S1
POWER SUPPLY = 220V
The fields included in the system status information displays are listed below:
NODE The node number (0 through 255) assigned to the FCD-E1.
NAME The system name assigned to the FCD-E1.
NODAL CLOCK Indicates the nodal clock source: INT, CH1, CH2, ML or SL.
SOFTWARE VER The software version of the FCD-E1.
HARDWARE VER The hardware version of the FCD-E1.
FCD TYPE According to equipment type: X denotes the number of data channels
(1 or 2), S1 denotes the sublink (if exists).
POWER SUPPLY Indicates the power supply type installed in the FCD-E1.