Unit installation

Appendix D Command Language Installation and Operation Manual
D-38 Supervisory Terminal Commands FCD-E1
The distance is assigned as follows:
 Each segment between two IP routers is assigned a weight of 6. For
example, when the path to an agent passes two FCD-E1 units with
their SNMP management enabled, the distance is 12.
 When the management network includes one or more additional
distinct (alternate) paths between two IP routers that connect to the
same remote agent, each such path is assigned a weight of 7 (6 + 1),
8 (6 + 2), etc. per segment. For example, if the route in the example
given above has an additional path in parallel with one segment, the
additional route has a distance of 13; when additional paths are
found in parallel with each segment, the distances will be 13, 14, 15.
DSP ST CH
Purpose
Display status information the data channel.
Syntax
DSP ST CH {1 2}
Use
To display the data channel status information, type:
DSP ST CH 1<Enter> or DSP ST CH 2<Enter>
A typical channel status display is shown below:
STATUS OF CHANNEL - 1
LOOPS TYPE = LOCAL REMOTE BERT T_INBAND R_INBAND
NO NO NO NO NO
PORT STATE = NOT CONNECTED
RTS STATE = OFF
INTERFACE = V.35
The fields included in the status information display are listed below:
LOOPS TYPE Displays the current state of the loops and tests on the data channel.
The LOCAL field indicates the state of the local loopback:
NO local loopback is deactivated.
YES local loopback is activated.
The REMOTE field indicates the state of the remote loopback:
NO remote loopback is deactivated.
YES remote loopback is activated.
The BERT field indicates the state of the BER test:
NO BER test is deactivated.
YES BER test is activated.
T_INBAND This field displays NO to indicate that the user requested the sending of
the inband remote loopback activation sequence.