Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-37
ESF ERROR EVENTS = [0] ..... [1000]
CURRENT ES = [0] ..... [900]
CURRENT UAS = [0] ..... [900]
CURRENT SES = [0] ..... [900]
CURRENT BES = [0] ..... [900]
CURRENT LOFC = [0] ..... [255]
CURRENT CSS = [0] ..... [255]
CURRENT TIMER = [0] ..... [900]
INTERVAL mm ES=nnn UAS=nnn BES=nnn SES=nnn LOFC=nnn CS=nnn
24 HOUR ES = [0] ..... [65535]
24 HOUR UAS = [0] ..... [65535]
24 HOUR SES = [0] ..... [65535]
24 HOUR BES = [0] ..... [65535]
24 HOUR LOFC = [0] ..... [255]
24 HOUR CSS = [0] ..... [255]
LAST 24 DEGRADE MIN = [0] ..... [1440]
24 HOUR INTERVAL = [0] ..... [96]
where: mm is 0 to 96 and nnn is 0 to 900.
DSP REM AGENT
Purpose
Display information on the SNMP agents that are known to the IP router of the
FCD-E1 when SNMP management is enabled.
Syntax
DSP REM AGENT
Use
1. To display the remote agent information, type:
DSP REM AGENT<Enter>
If no agent is known, you will see a CANNOT FIND ANY REMOTE AGENT
message. Otherwise, you will see a table listing the remote agents. A typical
table is shown below:
IP ADDRESS MUX NAME DISTANCE
-----------------------------------------
192.114.50.2 FCD2 006
The fields displayed for each agent are as follows:
IP ADDRESS The IP address of the remote agent.
MUX NAME The logical name of the remote agent.
DISTANCE The distance is a metric that indicates the logical distance (through the
management network) to the remote agent, and is used, among other
factors, in the selection of the optimal route to be used by the
management traffic.