Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-33
Syntax
DEF TERM {‘terminal type’}
Use
1. To reset the terminal control codes to 0, type:
DEF TERM<Enter>
2. To select the control codes for one of the above-mentioned types, type:
DEF TERM ‘terminal type’<Enter>
where ‘terminal type’ stands for TV920, VT52, VT100, Freedom100 or
Freedom220.
3. Press <Enter> again to end.
DSP AGENT
Purpose
Display the FCD-E1 agent parameters.
Syntax
DSP AGENT
Use
To display the agent parameters, type:
DSP AGENT
You will see the SNMP parameters data form. A typical form is shown
below:
AGENT PARAMETERS
--------------------
IP ADDRESS IS : = XXX.XXX.XXX.XXX
MAC ADDRESS IS : = XXX.XXX.XXX.XXX.XXX.XXX
Refer to the DEF AGENT on page D-15 for an explanation of the information
displayed by this command.
DSP ALM
Purpose
Display the contents of the alarm buffer. This buffer can contain up to 100 alarms.
Syntax
DSP ALM [Option]
Use
1. To display the complete contents of the buffer, type:
DSP ALM<Enter>