Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-29
2. Type the required password (4 to 8 characters). Carefully check that the
specified password has been indeed typed in, and then press <Enter>. The
new password is displayed in the following format:
CURRENT PASSWORD = ‘password’
Before entering a new password, make sure that the PASSW section of the FCD-E1
internal switch S1 is not set to ON, because in such case the default password
(RAD) is enforced.
DEF SL
Purpose
Select the sublink parameters. Refer to Table D-2 for the parameter description,
allowable ranges and configuration guidelines.
Syntax
DEF SL
Use
1. To define the sublink parameters, type:
DEF SL<Enter>
You will see the first line of the sublink parameters data form. A typical
data form is shown below:
FRAME CRC-4 SYNC IDLE_TS_CODE RAI
G732N NO CCITT 3F DISABLE
2. Select the desired parameters, and then press <Enter>. You will see the next
line of the data form:
CGA OOS_SIG OOS_CODE
NONE N/A 00
3. Select the desired parameters, and then press <Enter> to display the next
line:
MAP_MODE START_TS TS_TYPE NUM_OF_TS
USER N/A N/A N/A
Note