Unit installation

Appendix D Command Language Installation and Operation Manual
D-28 Supervisory Terminal Commands FCD-E1
FCD-E1 displays the node entry form:
NODE (0 to 255) = 0
2. Type the desired number in the range of 0 to 255, and press <Enter> to end.
Before entering a node number, make sure that section 2, PASSW, of the FCD-E1
internal switch S1 is not set to ON, because in such a case the default number (0) is
enforced.
DEF ROUTE
Purpose
Define the network management stations to be statistically routed via the
supervisory port. Up to five stations can be defined. The data is sent to the defined
stations via the supervisory port regardless whether the station was predefined in
the FCD-E1 network database or not.
Syntax
DEF ROUTE
Use
The use and the display format are similar to the DEF MANAGER LIST command.
The typical display is shown below:
ROUTE IP ADDRESS 1 IS: = 000.000.000.000
ROUTE IP ADDRESS 2 IS: = 000.000.000.000
ROUTE IP ADDRESS 3 IS: = 000.000.000.000
ROUTE IP ADDRESS 4 IS: = 000.000.000.000
ROUTE IP ADDRESS 5 IS: = 000.000.000.000
DEF PWD
Purpose
Define a new user password for FCD-E1.
Syntax
DEF PWD
Use
1. To define a new user password , type:
DEF PWD
The current password entry screen appears:
OLD PASSWORD = ‘old password’
where ‘old password’ is the current password. The current password is
followed by the password entry form:
NEW PASSWORD [4 TO 8 CHARS] =
Note