Unit installation

Appendix D Command Language Installation and Operation Manual
D-26 Supervisory Terminal Commands FCD-E1
You will see the first line of the main link parameters data form. A typical
data form is shown below:
FRAME CRC-4 SYNC IDLE_TS_CODE RAI
G732N NO CCITT 3F DISABLE
2. Select the desired parameters, and then press <Enter> to end.
DEF MANAGER LIST
Purpose
Define or modify the network management stations to which the SNMP agent of
this FCD system will send traps. You can define up to five managers. Each network
management station is defined by entering its IP address and the corresponding
subnet mask.
Syntax
DEF MANAGER LIST
Use
1. To define a management station, type:
DEF MANAGER LIST<Enter>
2. You will see the first line of the managers list data form, which is used to define
the IP address of the first management station. Type in the IP address of the
desired management station. Use the dotted-quad format (four groups of digits
in the range of 0 through 255, separated by periods).
3. After filling in the required address, press <Enter> to display the next line,
and then type in the subnet mask in the dotted-quad format. The mask
consists of four groups of digits in the range of 0 to 255, separated by periods.
The net section must consist of 1s.
A typical data form, as seen after both lines used to define the first
management station have been filled in, is shown below:
IP ADDRESS 999.999.999.999
SUBNET MASK 999.999.999.999
4. Repeat the procedure described above to define the additional management
stations (No. 2 through 5). After pressing <Enter> for the subnet mask of the
fifth manager, you will see the current list in the following format: