Unit installation

Appendix D Command Language Installation and Operation Manual
D-22 Supervisory Terminal Commands FCD-E1
3. When done, press <Enter> to display the second page of the call-out
parameters data form. A typical display is shown below.
NEW PRIMARY NUMBER [MAX 20 CHARS] =
CURRENT PRIMARY DIAL COMMAND = ‘primary number’
The second page is used to enter a new primary directory number, and the
second row displays the current primary directory number. The directory
number can include up to 20 digits, including the * and # symbols.
4. After entering the desired directory number, press <Enter>:
 If the ALT_NUM_MODE parameter is NO (no alternate number), FCD-E1
displays the TIME and DATE fields, followed by the FCD-E1 prompt.
 If the ALT_NUM_MODE parameter is YES, press <Enter> to see the third
page of the call-out parameters data form, used to enter a new alternate
directory number. A typical display is shown below.
NEW ALTERNATE NUMBER [MAX 20 CHARS] =
CURRENT ALTERNATE NUMBER = ‘alternate number’
5. After entering the desired directory number, press <Enter> to end.
DEF CHANNEL
Purpose
Define the data channel parameters. Refer to Table D-4 for the parameter
description, allowable ranges and configuration guidelines.
Syntax
DEF CH {1 2}
Use
1. To define the data channel parameters, type:
DEF CH 1<Enter> or DEF CH 2<Enter>
Specifying channel 2 for an FCD-E1/1/*, promotes ERROR 054 (illegal parameter for
current configuration).
The first line of the channel parameters data form is displayed.
MULTIPLIER SPEED(KBPS) FIFO_SIZE
CLK_MODE CTS
64 NC AUTO DCE ON
2. Change the desired parameters and then press <Enter> to display the next
line. If the channel interface is ETHERNET, you will see the Ethernet port
configuration parameters line, otherwise you will see the timeslot mapping line
(Step 3 below). A typical Ethernet port configuration parameters line is shown
below.
Note