Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-21
Table D-8. Call-Out Parameters
Parameter Function Values
NUM_OF_RETRIES
Used to control the number of dialing
retries.
This parameter applies to both the
primary and the alternate number.
• If the call is not established after
dialing the primary directory number
for the specified number of times,
FCD-E1 attempts to establish the call
by dialing the alternate directory
number (provided the use of an
alternate number is enabled by
means of the ALT_NUM_MODE
parameter).
• If the call cannot be established
within the specified number of
redialing attempts on neither of the
two directory numbers, FCD-E1 stops
the call attempts. When a new alarm
report must be sent, the call attempts
are started again. The user is notified
that the call attempts failed by a
message recorded in the alarm buffer
(separate messages are provided for
each directory number).
0 – no redialing attempts are made in
case the call is not established on the
first attempt.
1–8 – in case the call is not
established on the first attempt,
FCD-E1 redials for the specified
number of times.
Default: 0
WAIT_FOR_CONNECT
Specifies the time FCD-E1 waits for an
answer after each dialing attempt.
• If the called station does not answer
within the specified time, FCD-E1
disconnects. If additional call
attempts are allowed, FCD-E1 redials
immediately after disconnecting.
The available selections are 30, 45, or
60 seconds.
Default: 30
DIAL_MODE
Used to select the dialing mode The
appropriate dialing mode depends on
the dialing mode supported by the
telephone network.
TONE – the modem is instructed to
use DTMF dialing.
PULSE – the modem is instructed to
use pulse dialing.
Default: TONE
ALT_NUM_MODE
used to control the use of an alternate
number. The alternate number is dialed
used after the specified number of call
attempts on the primary number failed
NO – no alternate number. In this
case, FCD-E1 stops the call attempts
after the specified number of call
attempts on the primary number
failed.
YES – the use of an alternate number
is enabled.
Default: NO