Unit installation

Appendix D Command Language Installation and Operation Manual
D-16 Supervisory Terminal Commands FCD-E1
2. Select the desired value by pressing <F> or <B>, then press <Enter> to
display the second line. Continue until all the parameters are defined, and
then press
<Enter> to continue.
A typical display, as seen after all the parameters are selected, is shown below:
CURRENT AGENT PARAMETERS
------------------------
IP_ADDRESS IS : = XXX.XXX.XXX.XXX
MAC_ADDRESS IS : = XXX.XXX.XXX.XXX.XXX.XXX
READ COMMUNITY IS : = PUBLIC
WRITE COMMUNITY IS : = PRIVATE
TRAP COMMUNITY IS : = PUBLIC
where X stands for the digits of the IP and MAC address.
Table D-7 lists the agent’s parameters, function and range of values.
Table D-7. SNMP Agent Parameters
Parameter Function Values
TELNET_APATHY_TIME
Selects the time, in minutes, after
which a Telnet connection will be
automatically terminated if no
incoming activity is detected.
The available values are 10 min,
15 min and 20 min.
Default: 10MIN
IP_ADDRESS
Type in the IP address assigned to the
FCD-E1 SNMP agent
Use the dotted-quad format (four
groups of digits in the range of 0
through 255, separated by periods).
Default: 999.999.999.999
MAC ADDRESS
Type in the MAC address assigned to
the FCD-E1 SNMP agent
Use the dotted-quad format (six
groups of digits in the range of 0
through 255, separated by periods).
Default: 999.999.999.999.999.999
READ COMMUNITY
Type in the name of the SNMP
community that has read-only
authorization (the FCD-E1 SNMP
agent will accept only getRequest
and getNextRequest commands
from management stations using that
community).
Up to seven alphanumeric characters.
Default: public
WRITE COMMUNITY
Type in the name of the SNMP
community that has read-write
authorization (the FCD-E1 SNMP
agent will also accent setRequest
commands from management
stations using that community).
Up to seven alphanumeric characters.
Default: private
TRAP COMMUNITY
Type in the name of the SNMP
community to which the FCD-E1
SNMP agent will send traps.
Up to seven alphanumeric characters.
Default: public