Unit installation

Appendix D Command Language Installation and Operation Manual
D-14 Supervisory Terminal Commands FCD-E1
CLR LOOP
Purpose
Deactivate the specified user-initiated test or loopback.
Syntax
CLR LOOP
Use
1. To deactivate a main link loopback, type:
CLR LOOP LOCAL ANALOG ML<Enter> or CLR LP LOC ANA ML<Enter>
CLR LOOP REMOTE ANALOG ML<Enter> or CLR LP REM ANA ML<Enter>
CLR LOOP LOCAL DIGITAL ML<Enter> or CLR LP LOC DIG ML<Enter>
CLR LOOP REMOTE DIGITAL ML<Enter> or CLR LP REM DIG
ML<Enter>
To deactivate all main link loopbacks and tests, type:
CLR LOOP ML<Enter> or CLR LP ML<Enter>
2. To deactivate a sublink loopback, type:
CLR LOOP LOCAL ANALOG SL<Enter> or CLR LP LOC ANA SL<Enter>
CLR LOOP REMOTE ANALOG SL<Enter> or CLR LP REM ANA SL<Enter>
CLR LOOP LOCAL DIGITAL SL<Enter> or CLR LP LOC DIG SL<Enter>
CLR LOOP REMOTE DIGITAL SL<Enter> or CLR LP REM DIG SL
<Enter>
CLR LOOP BERT SL<Enter> or CLR LP BERT SL <Enter>
CLR LOOP INBAND SL<Enter> or CLR LP INBAND SL <Enter>
To deactivate all sublink loopbacks and tests, type:
CLR LOOP SL<Enter> or CLR LP SL<Enter>
3. To deactivate a channel loopback, type:
CLR LOOP LOCAL CH X<Enter> or CLR LP LOC CH X<Enter>
CLR LOOP REMOTE CH X<Enter> or CLR LP REM CH X<Enter>
CLR LOOP BERT CH X<Enter> or CLR LP BERT CH X<Enter>
CLR LOOP INBAND CH X<Enter> or CLR LP INBAND CH X<CR
where X stands for the channel number.
To deactivate all channel loopbacks and tests, type:
CLR LOOP CH X<Enter> or CLR LP CH X<Enter>
The deactivation of an inband loopback is made by repeatedly transmitting the
deactivation sequence, therefore the loopback can be considered as deactivated
only after approximately 2 seconds.
If no user-initiated loopback of the specified type is now connected, you will
receive ERROR 052 (loop is not active).
Note