Unit installation

Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-13
D.3 Supervisory Terminal Commands
The commands described in this section are listed in alphabetical order (see the
FCD-E1 Explicit Command Set Index table for a complete list). If you need
explanations on mnemonic commands, first use the FCD-E1 Mnemonic Command
Set Index table in Chapter 4 to find the corresponding explicit command format.
The description includes the command format, usage, and options.
The following notational conventions are used below:
[ ] square brackets indicate optional entry/parameter.
{ } accolades indicate required entry/parameter.
‘ ‘ single quotes delimit user entry.
<Enter> indicates the pressing of the carriage return key.
The screens appearing in this appendix are given for illustration purposes only, and
must not be construed as providing typical parameter values. Parameter values must
be selected in accordance with the specific requirements of each particular
application. If necessary, contact RAD Technical Support Department.
BYE
Purpose
End the current Telnet session.
Syntax
BYE
Use
To end the current Telnet session, type:
BYE <Enter>
CLR ALM
Purpose
Clear the alarm buffer.
Syntax
CLR ALM [/A]
Use
To clear all the alarms (including ON/OFF alarms) type:
CLR ALM /A<Enter>
Note