Unit installation

Appendix D Command Language Installation and Operation Manual D-10 Front Panel Parameters FCD-E1
Table D-4. Data Channel Configuration Parameters (Cont.)
Designation Function Values Configuration Guidelines MAP MODE
Selects the timeslot allocation method used for this data channel
USER – Free user selection of timeslots. SEQ – Sequential allocation of timeslots, starting from a user-specified slot. Default: USER
Select the desired mode, in accordance with system requirements. Remember that for each data channel, it is necessary to assign a number of main link timeslots equal to the n, the multiple of the basic rate that determines the channel data rate. Therefore, when you select the SEQ mode and a starting timeslot, FCD-E1 attempts to allocate the required number n of timeslots to the channel.
Timeslot 16 is automatically skipped when G732S framing is used, however all the other timeslots within the required range are automatically included. This may result in conflicts with previous assignments. Such conflicts are automatically detected and reported by error messages. In case of conflict, you may use the USER mode to assign individual free timeslots to the data channel, until the required number of timeslot is reached.
Note: All the timeslots assigned to data channels are always defined as data timeslots; this, however, does not preclude their use as voice channel carriers. TS TYPE 1..31 (when USER is selected in MAP MODE parameter) TS TYPE (when SEQ is selected in MAP MODE parameter)
Selects the timeslot connection state
NC – Timeslot not connected DATA – Timeslot is connected and is handled as a data timeslot Default: NC
START_TS
Selects the starting timeslot for SEQ timeslot allocation
Any number in the range of 1 to 31, consistent with the desired number of user timeslots and when applicable, with the timeslots used by the sublink. Default: 1