Unit installation

Appendix A Pinouts Installation and Operation Manual
A-12 Data Channel Connector FCD-E1
Table A-10. Wiring of V.36/RS-449 Adapter Cable for DTE1 Mode
FCD-E1 Side Designation Function User’s Side
1 FG Frame Ground 1
2 SDA Send Data (wire A) 6
3 RDA Receive Data (wire A) 4
4 RTSA RTS (wire A) 13
5 CTSA CTS (wire A) –
6 DSRA DSR (wire A) 12
7 SG Signal Ground 19
8 DCDA DCD (wire A) 7
9 RCB Receive Clock (wire B) 35
10 DCDB DCD (wire B) 25
11 SCEB External Send Clock (wire B) 26
12 SCB Send Clock (wire B) –
13 CTSB CTS (wire B) –
14 SDB Send Data (wire B) 24
15 SCA Send Clock (wire A) –
16 RDB Receive Data (wire B) 22
17 RCA Receive Clock (wire A) 17
18 – Not connected –
19 RTSB RTS (wire B) 31
20 RCEA External Receive Clock (wire A) –
21 – Not connected –
22 DSRB DSR (wire B) 24
23 RCEB External Receive Clock (wire B) –
24 SCEA External Send Clock (wire A) 8
25 – Not connected –
DTE2 Mode
This mode is used to connect to user’s equipment with V.36/RS-449 DCE interface
that provides the transmit and receive clocks to the FCD-E1 data channel.
The V.36/RS-449 cable coming from the user’s equipment is connected to the
FCD-E1 CHANNEL connector through an adapter cable. The adapter cable (see
Figure A-4) is terminated in a 25-pin male D-type connector at the FCD-E1 side,
and a 37-pin female connector at the user’s side. A suitable cable, designated
CBL-HS2/R/3, is available from RAD.
Cable wiring is given in Table A-11.