Unit installation

Chapter 6 Troubleshooting and Diagnostics Installation and Operation Manual
6-6 Detecting Errors FCD-E1
Table 6-2. FCD-E1 Configuration Error Messages (Cont.)
Error Code Terminal Message Description
ERROR 07 CHANNEL SPEED NOT MATCH
OPEN NUMBER OF TS
The number of time slots currently allocated to a data
channel is not equal to the number of time slots required
to support the nominal data rate configured for that
channel. Either increase the number of time slots, or
reduce the channel data rate.
ERROR 08 FCD IN LOOP CAN’T UPDATE
HARDWARE
When a test or loopback is active, it is not possible to
change the FCD-E1 operating mode in accordance with
the updated configuration parameters. You may see this
message either after pressing ENTER, or after a update
data base command has been received through the
supervisory port (or inband management). You must first
deactivate the test or loopback.
ERROR 09 CONFLICT BETWEEN CLOCK
MODE AND FIFO SIZE
You are trying to select the DCE or DTE1 clock mode
when the FIFO size is not AUTO. A specific FIFO size can
be selected only for the DTE2 mode. Select AUTO.
ERROR 10 ILLEGAL TIME SLOT
ALLOCATION
At least one main link time slot is being assigned to more
than one user. Check the time slot assignment for each
channel and for the sublink, with particular attention to
automatic assignments (SEQ and ALT modes).
ERROR 11 TIME SLOT OUT OF RANGE When using the SEQ or ALT mapping mode, the sum of
the number of time slots requested for a data channel (or
sub) and the starting time slot for that channel exceeds
31. Check and change as required.
ERROR 12 ILLEGAL UNFRAME
CONFIGURATION
You are trying to configure UNFRAME mode incorrectly.
Before selecting the UNFRAME mode, you must
disconnect all the main link time slots from ports.
ERROR 13 ILLEGAL SPEED FOR AUXILIARY
DEVICE
The AUTO (Autobaud) mode cannot be selected when
the supervisory port is to support the SLIP protocol (AUX
DEV parameter is set to SLIP-NMS).
ERROR 14* WRONG IP ADDRESS The syntax of the IP address is incorrect. The IP address
must be entered in the dotted-quad format (four numbers
in the range of 0 through 255, separated by periods), as
explained in Appendix B.
ERROR 15* WRONG MAC ADDRESS The syntax of the MAC address is incorrect (the MAC
address must be entered as six numbers in the range of 0
through 255, separated by periods).
ERROR 16 DEDICATE TIME-SLOT IS
MAPPED
The time slot you are trying to select for use as the
dedicated inband management time slot on that link is
already assigned. Check and change as required.
ERROR 17 ILLEGAL DOWNLOAD MODE You are trying to enable downloading while using the
UNFRAME mode When using the UNFRAME mode, you
must disable downloading.
ERROR 18 CONFLICT BETWEEN SYSTEM
CLK AND CHANNEL CLK
A channel is configured to use the clock mode DTE2, but
the master clock source is not configured to use that
channel. Check and change as required.