Unit installation

Installation and Operation Manual Chapter 4 Configuration
FCD-E1 Supervision Terminal Operating Instructions 4-23
2. If your command is not correct, the FCD-E1 will not execute it, but will echo
again the command, with a BAD COMMAND message in the following line.
Type again the correct command.
3. If the terminal screen fills up during the exchange with the FCD-E1, you will
see the message:
HIT ANY KEY TO CONTINUE
After pressing any key except BREAK, the terminal scrolls to the next page.
Ending a Control Session
1. To end the control session, type:
EXIT
The command used to end Telnet sessions is BYE.
2. The FCD-E1 prompt will disappear. Now you can control the FCD-E1 from its
front panel.
A control session may also be terminated by the FCD-E1 if the idle disconnect
time-out is enabled, or when the DTR line switches to the inactive (OFF) state.
Note