Unit installation

Chapter 4 Configuration Installation and Operation Manual
4-18 Using the Menu-Driven Command Mode FCD-E1
Using the Mnemonic Mode
To use the mnemonic mode, the only command that needs to be remembered is
MM, the command that displays the top-level menu.
After entering the top-level menu, you can read the command needed to proceed
to the next lower level, on the path to the command that performs the desired
action.
Table 4-5 displays the mnemonic mode menu structure.
Table 4-5. Mnemonic Mode Menu Structure
MM Main Menu
MA Set the date for the FCD-E1 internal clock
MT Set the time for the FCD-E1 internal clock
MX End the current control session
MF Define special supervision terminal codes
MP Enter the user password at the start of a new session; followed by the password itself
MH Display a concise index of commands and option switches
ME Reserved
MY Disconnet Telnet session
MS Display Commands Menu
SA Display the alarm buffer contents
ST Display timeslots assignment
SE Display agent
SH Display the results of the last periodical hardware self-test
SG Display information on the remote SNMP agents handled by the FCD-E1 IP router
SB Display BER test results submenu
SB1 Display the results of the last BER measurement made on channel 1
SB2 Display the results of the last BER measurement made on channel 2
SBS Display the results of the last BER measurement made on sublink
SF Display FDL Menu
SFM FDL of main link
SFS FDL of sublink
SS Display status menu
SSY Display system status information
SSM Display status information on the main link
SSS Display status information on the sublink
SS1 Display status information on channel 1
SS2 Display status information on channel 2
SP Display performance monitoring menu
SPM Display contents of main link performance monitoring registers, and optionally clear them
SPS Display contents of sublink performance monitoring registers, and optionally clear them