Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 FCD-E1LC Command Language FCD-E1LC Ver. 1.0
To cancel command execution, press <Ctrl+C>; the FCD> prompt appears, and you
can enter a new command.
You can also use <Ctrl+C> to stop the automatic repetition of commands sent
with the /R option.
You can recall and edit previous commands by pressing <Ctrl+A>. FCD-E1LC stores
the last 10 commands in a special buffer, and each <Ctrl+A> pressing retrieves
the previous command from that buffer. The retrieved command appears on the
command line, and can be edited as desired.
Press <Ctrl+D> to execute again the last command.
If an idle disconnect time-out is specified, FCD-E1LC automatically disconnects
the ongoing session if no command is received from the terminal for the
specified time-out interval.
If you enter an invalid command, FCD-E1LC does not execute it and displays the
following:
• If the command is not valid in the current system configuration, or the values
you are trying to set are incorrect, FCD-E1LC displays an appropriate error
message. For a list of configuration error messages, refer to
Configuration
Error Messages
in Chapter 4 .
• If the command syntax is incorrect, FCD-E1LC displays the following message:
Bad command or parameter. Type ‘h’ for help
In this case you must enter the correct command.
If the terminal screen fills up during the exchange with the FCD-E1LC, it displays
the following message:
HIT SPACE–BAR TO CONTINUE
After pressing the spacebar, the terminal scrolls to the next page.
What to Do If …
If FCD-E1LC does not respond to any command entered at the terminal, this may
be caused by one of the following:
• FCD-E1LC is configured to use a protected password: to correct, select first
the factory-default password.
• CONTROL DCE communication parameters are not identical to those of the
terminal: to correct, select first the factory-default parameters.
Selecting the Factory-Default Password
The FCD-E1LC is delivered with password protection disabled. If the password
protection has been enabled (using the DEF SP command), you must enter a
password when you start a control session. If the password is incorrect, the
FCD-E1LC will not respond. However, even if the current password is not known,
you can establish management communication with the FCD-E1LC by appropriate
setting of the PSW section of SW2, located on the FCD-E1LC main board. Set the
PSW section of SW2 as follows:
Note