Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring for Management FCD-E1LC Ver. 1.0
Configuring for Telnet or SNMP Management
FCD-E1LC can be managed by Telnet or SNMP via inband management or over the
control port using SLIP or PPP.
To prepare the FCD-E1LC system for configuration by means of Telnet hosts
and/or SNMP management stations, use the supervision terminal to configure the
supervisory port and the SNMP agent as explained below.
Configure the SNMP Agent
• Define the FCD-E1LC system name, using the DEF NAME command.
• Define the FCD-E1LC SNMP agent parameters using the DEF AGENT
command. The IP addresses of the SNMP agent and IP host must be within
the same IP subnet, and the various community names must match those of
the IP host. A typical SNMP agent parameters data form is shown below:
TELNET_APATHY_TIME = 10 MIN
IP_ADDRESS = XXX.XXX.XXX.XXX
SNMP READ COMMUNITY = public
SNMP WRITE COMMUNITY = private
SNMP TRAP COMMUNITY = public
where X stands for the digits of the prescribed IP address.
Configure the Inband Management
1. Type DEF DNLOAD ML to configure the FCD-E1LC inband management
parameters for the main link or DEF DNLOAD SL to configure the sublink
inband management parameters.
2. Define the desired management mode: TS0/F or Frame Relay.
If you selected TS0/F, National Bits configuration screen appears:
DNLOAD MODE
TS0/F
SA_BIT_4 SA_BIT_5 SA_BIT_6 SA_BIT_7 SA_BIT_8
ZERO ZERO ZERO ZERO ZERO
If you selected Frame Relay, the dedicated TS configuration screen
appears:
DNLOAD MODE
FRAME_RL
TS_NUM SPEED
30 64
3. Select the required parameters as described in Appendix D (DEF DNLOAD ML
and DEF DNLOAD SL commands).
Note