Specifications

FCD-E1LC Ver. 1.0 Configuring for Management 4-1
Chapter 4
Configuration
This chapter provides configuration guidelines for configuring FCD-E1LC.
The configuration activities presented in this chapter require that the FCD-E1LC
be first configured using a standard ASCII terminal, as explained in
Chapter 3 .
However, after performing the preliminary configuration of the terminal and the
FCD-E1LC in accordance with
Chapter 3 , the same configuration activities can also
be performed by means of a Telnet host, or an SNMP network management
station.
For general information regarding the supervision language syntax, usage and
commands, see
FCD-E1LC Command Language below .
Detailed descriptions of each command appear in Appendix D .
4.1 Configuring for Management
The scope of the preliminary configuration activities is to enable management
communication with the FCD-E1LC system.
See
Chapter 2 for detailed information on internal settings, and connection
instructions.
Configuring the Supervision Terminal
The software necessary to run the FCD-E1LC control program is contained in the
FCD-E1LC unit. To initialize FCD-E1LC for correct terminal operation, the control
port parameters should be set as described in
Table 4-1 .
Table 4-1. Control Port Communication Parameters
Parameter Settings for Terminal Management Session Default
Speed The FCD-E1LC control port can communicate at rates of 1200,
2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps. You
can configure a specific rate, or enable the Autobaud function.
AUTO
Data Word The word format consists of one start bit, 8 data bits, and one or
two stop bits.
1 stop
bit
Parity Parity can be odd, even or none. None
Interface For direct connection, choose DCE.
For connection through a modem or data link, choose DTE.
DCE