Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-49
NODAL CLOCK Indicates the nodal clock source: INT, CH1, CH2 or ML.
SOFTWARE VER The software version of the FCD-E1LC.
HARDWARE VER The hardware version of the FCD-E1LC.
FCD TYPE Indicates the type and the number (1 or 2) of data channels
of this FCD-E1LC.
DSP TS
Purpose
Display information on the use and type of main link timeslots.
Syntax
DSP TS
Use
• To display the timeslot information, type:
DSP TS<Enter>
A typical display is shown:
TS : 01 02 03 04 05 06 07 08 09 10
TYPE : DATA NC DATA DATA DATA NC DEDIC DATA DATA NC
DEST : CH1 NA CH2 NA NA NA ML CH1 NA NA
TS : 11 12 13 14 15 16 17 18 19 20
TYPE : DATA NC DATA DATA DATA DATA NC DATA DATA NC
DEST : CH1 NA CH1 NA NA NA NA CH2 NA NA
TS : 21 22 23 24 25 26 27 28 29 30 31
TYPE : DATA NC DATA DATA DATA NC DATA DATA DATA NC NC
DEST : CH1 NA NA CH2 NA NA NA CH1 NA NA NA
The fields included in the timeslot displays are listed below:
TS Indicates the main link timeslot number, 1 through 31.
TYPE Indicates the timeslot utilization:
• NA – timeslot not connected (FCD-E1LC inserts the idle code in
such timeslots).
• DATA – data channel.