Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-45
2. To display the remote agent information including management stations that
are connected to FCD-E1LC, type:
DSP REM AGENT /A<Enter>
You will see a table listing the remote agents. A typical table is shown
below:
IP ADDRESS MUX NAME DISTANCE
192.114.029.209 ** NMS ** 15
192.168.238.196 ** NMS ** 12
192.168.238.244 ** NMS ** 9
192.114.027.036 ** NMS ** 7
192.168.238.061 ** NMS ** 2
192.168.238.001 ** NMS ** 3
192.168.200.253 ** NMS ** 3
192.168.238.203 fcd245 5
DSP ST CH
Purpose
Display status information on serial data channels.
Syntax
DSP ST CH CC
Use
• To display the data channel status information, type:
DSP ST CH CC<Enter>
where CC is the desired channel number, 1 or 2.
A typical channel status display is shown below:
STATUS OF CHANNEL – X
LOOPS TYPE = LOCAL REMOTE
NO NO
PORT STATE = CONNECTED
RTS/CONTROL STATE = OFF
INTERFACE = V.35
The fields included in the status display are listed below:
LOOPS Displays the current state of the loopbacks activated on the data
channel.
The LOCAL field indicates the local loopback state: