Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-44 Commands FCD-E1LC Ver. 1.0
DSP PM SL
Display the contents of the sublink performance monitoring registers specified by
AT&T Pub. 54016. For an explanation of the performance monitoring registers,
refer to the
Performance Diagnostic Data section in Chapter 4 .
Syntax
DSP PM SL [/C] [/CA]
Use
The sublink configuration parameters are similar to those of the main link. Refer
to the DSP PM ML command for detailed information.
DSP REM AGENT
Purpose
Display information on the remote SNMP agents that are known to the FCD-E1LC
management traffic router, provided SNMP management is enabled.
Syntax
DSP REM AGENT
Use
1. To display the remote agent information, type:
DSP REM AGENT<Enter>
A typical table listing the remote agents is shown below:
IP ADDRESS MUX NAME DISTANCE
- - – - - - - - - - - - - - - - - - - - - - - -
192.114.050.002 New-York 13
192.114.150.122 Chicago 9
If no remote agents are known, you will see a CANNOT FIND REMOTE AGENTS.
The fields displayed for each agent are as follows:
IP ADDRESS The IP address of the remote agent.
MUX NAME The logical name of the remote agent.
DISTANCE Metric that indicates the logical distance (through the
management network) to the remote agent, and is used,
among other factors, in the selection of the optimal route to
be used by the management traffic.
Note