Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-41
Use
To display the hardware test report, type:
DSP HDR TST<Enter>
The display has one field that shows NO HARDWARE FAILURE if everything checks
well, or lists the detected problem: EPROM FAILURE, I/O EXP FAILURE, COUNTER
FAILURE, ILLEGL SYS CNFG or SFIFO FAIL.
DSP MANAGER LIST
Purpose
Display the network management stations to which the SNMP agent of this
FCD-E1LC system sends traps. The information that is provided for each network
management station includes its IP address and the corresponding subnet mask.
Syntax
DSP MANAGER LIST
Use
• To display the current list of network management stations, type:
DSP MANAGER LIST<Enter>
You will see the list of network management stations that receive traps
generated by this FCD-E1LC system. A typical display is shown below:
MANAGERS LIST PARAMETERS
MANAGER 1 IP ADDRESS IS : 192.114.029.209
MANAGER 1 SUBNET MASK IS : 255.255.255.240
MANAGER 2 IP ADDRESS IS : 192.168.238.196
MANAGER 2 SUBNET MASK IS : 255.255.255.000
MANAGER 3 IP ADDRESS IS : 192.168.238.244
MANAGER 3 SUBNET MASK IS : 255.255.255.240
MANAGER 4 IP ADDRESS IS : 192.114.027.036
MANAGER 4 SUBNET MASK IS : 255.255.255.000
MANAGER 5 IP ADDRESS IS : 192.168.238.061
MANAGER 5 SUBNET MASK IS : 255.255.255.240
DSP PM ML
Purpose
Display the contents of the main link performance monitoring registers specified
by AT&T Pub. 54016. For an explanation of the performance monitoring registers,
refer to the
Performance Diagnostic Data section in Chapter 4 .