Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-38 Commands FCD-E1LC Ver. 1.0
DEF TERM ‘terminal type’<Enter>
where ‘terminal type’ stands for TV920, VT52, VT100, Freedom100, or
Freedom220.
3. Press <Enter> again to end.
DSP AGENT
Purpose
Display the FCD-E1LC agent parameters.
Syntax
DSP AGENT
Use
To display the agent parameters, type:
DSP AGENT<Enter>
You will see the SNMP parameters data form. A typical form is shown
below:
AGENT PARAMETERS
- - - - - - - - -
IP ADDRESS IS : = 114.29.17.2
Refer to the DEF AGENT section for an explanation of the information displayed
by this command.
DSP ALM
Purpose
Display the contents of the alarm buffer. This buffer can contain up to
100 alarms.
Syntax
DSP ALM /CA
Use
• To display the complete contents of the buffer, type:
DSP ALM<Enter>
• To display the complete buffer contents and then clear all the alarms, type:
DSP ALM /CA<Enter>