Specifications
Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-35
Parameter Function Values Configuration Guidelines
LOG_OFF
Controls the idle
disconnect time of
the CONTROL DCE
port
NO – Automatic session
disconnection disabled. To end
the session, use the BYE
command.
3_MIN – Automatic
disconnection after 3 minutes if
no data is received by the
CONTROL DCE port.
10_MIN – Automatic
disconnection after 10 minutes
if no data is received by the
CONTROL DCE port.
Default: NO
CALL_OUT_
TRIGGER
Selects the type of
alarms that will
trigger the call-out
function (reporting
of alarms via a
modem connected
to the CONTROL
DCE port)
NONE – The call-out function is
disabled.
ALL – FCD-E1LC will initiate a call
after each new alarm.
MAJOR – FCD-E1LC will initiate a
call only when a new major
alarm condition is detected.
Default: NONE
ACTIVATE_
CALL_OUT
If CALL_OUT_
TRIGGER is not set
to NONE, defines
when the call-out
function is activated
ANY CASE – Call-out is activated
in any case.
LINK FAIL – Call-out is activated
only when a link failure occurs or
there is local or remote
synchronization loss.
Default: ANY CASE
AUXILIARY_
DEVICE
Selects the
management mode
supported by the
CONTROL DCE port.
TERMINAL – The CONTROL DCE
port is connected using an ASCII
supervision terminal.
NMS-SLIP – The CONTROL DCE
port connects to an SNMP
management station and/or
Telnet host using the SLIP
protocol.
NMS-PPP – The CONTROL DCE
port connects to an SNMP
management station and/or
Telnet host using the PPP
protocol.
SLIP-AGENT – The CONTROL DCE
port connects to another agent
port using the SLIP protocol. See
additional details in
Appendix B
.
Default: TERMINAL
Select NMS-SLIP or NMS-PPP
when the supervisory port
must be able to use the SLIP,
respectively NMS protocol, for
example for SNMP or Telnet
management.
If the management connection
to the FCD-E1LC CONTROL DCE
port uses a chain topology (for
example, when it is connected
to the serial port of a
Megaplex-2100), select
SLIP-AGENT.
Select TERMINAL if only the
supervision terminal must be
supported.