Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-34 Commands FCD-E1LC Ver. 1.0
Parameter Function Values Configuration Guidelines
INTERFACE
Selects supervisory
port interface
DCE – The CONTROL DCE port
appears as a DCE for external
equipment
DTE – The CONTROL DCE port
appears as a DTE, for connection
via modem to the external
equipment
Default: DCE
Select DCE when FCD-E1LC is
connected directly to the
terminal.
Select DTE when FCD-E1LC is
connected to the terminal via a
modem.
CTS
Controls the state
of the CTS line in
the CONTROL DCE
port
ON – CTS line is always ON
(active).
=RTS – CTS line tracks the RTS
line.
Default: =RTS
DCD_DEL
With the CONTROL
DCE port defined as
DTE, indicates the
delay (in msec)
between DCD=ON
and sending of data
The available values are 0, 10,
50, 100, 200, and 300 msec.
Default: 0
If you select a non-zero value
when the port interface is
programmed as DCE, you will
receive an error message.
DSR
Controls the state
of the DSR line
ON – DSR line is continuously
on. It will switch to OFF for five
seconds after the DTR line is
switched OFF.
=DTR – DSR line tracks the DTR
line.
Default: ON
If you select DSR=ON when INT
is set to DTE, you will receive
an error message.
POP_ALM
Controls the
automatic sending
of alarms to a
terminal connected
to the CONTROL
DCE port
YES – The terminal automatically
displays every 10 minutes the
alarm status (or whenever an
alarm which is not masked using
the DEF ALM MASK command
changes to ON).
NO – No automatic display.
Default: NO
PWD
Controls password
protection
YES – Password protection
enabled.
NO – Password protection
disabled.
Default: NO