Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-32 Commands FCD-E1LC Ver. 1.0
• VOICE – the timeslot is handled as a voice timeslot, that is, in addition to
transferring the timeslot to the main link, the associated signaling
information (carried in timeslot 16) is also copied to the corresponding bits in
timeslot 16 of the main link.
• DATA
– the timeslot is handled as a data timeslot, that is, when the FRAME
parameter is G732S, the associated signaling information (carried in timeslot
16) is ignored.
• The VOICE type can be selected only when the sub FRAME parameter is G732S.
• When the FRAME parameter is G732S , leave timeslot 16 as NC .
• If you already selected an inband management timeslot (using the DEF
DNLOAD SL command), the selected timeslot type appears as
DEDIC and you
cannot change this selection.
You must connect a number of sub timeslots equal to that required by the
equipment connected to the sublink. Any unconnected sublink timeslot is filled
with the selected sublink idle timeslot code.
Remember that some of the main link timeslots must be assigned to other
purposes, namely:
• The number of timeslots to be assigned on the main link to the data
channel(s)
• Signaling information (timeslot 16 when using G732S framing)
• Timeslot dedicated to inband management, when using the FRAME_RL mode.
This timeslot is selected using the DEF DNLOAD SL command (on the timeslot
map, this timeslot appears as DEDIC and you cannot change this selection).
DEF SP
Purpose
Define the supervisory (CONTROL DCE) port parameters. Refer to Table D-9 for
the parameter description, allowable ranges and configuration guidelines.
Syntax
DEF SP
Use
1. To define the supervisory port parameters, type:
DEF SP<Enter>
The first row of the supervisory port parameters data form is displayed. A
typical form is shown below. The form presents the current parameter
values as defaults.
Note