Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-27
Syntax
DEF PROMPT
Use
1. To select the supervisory port prompt, type:
DEF PROMPT <Enter>
The prompt selection form is displayed. A typical form is shown below:
PROMPT_TYPE
PRODUCT_NAME
2. To change the current selection, press <F> or <B>, then press <Enter> to end.
The available selections are as follows:
PRODUCT_NAME The prompt displays the equipment type, FCD, followed by >.
GIVEN_NAME The prompt displays the logical name assigned by means of the
DEF NAME command, followed by >.
DEF PWD
Purpose
Define a new user password for FCD-E1LC.
Syntax
DEF PWD
Use
1. To define a new user password, type:
DEF PWD<Enter>
The current password entry screen appears:
OLD PASSWORD = ‘old password’
where ‘old password’ is the current password. The current password is
followed by the password entry form:
NEW PASSWORD [4 to 8 CHARS] =
2. Type the required password (4 to 8 characters). Carefully check that the
specified password has been indeed typed in, and then press <Enter>.
The new password is displayed in the following format:
CURRENT PASSWORD = ‘password’
Before entering a new password, make sure that the PSW section of the
FCD-E1LC internal switch SW2 is not set to ON, because in such case the default
password (1234) is enforced.
Note