Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-20 Commands FCD-E1LC Ver. 1.0
Parameter Function Values Configuration Guidelines
ETHERNET MODE
Selects the Ethernet
LAN traffic transfer
mode when
auto-negotiation is
disabled.
This parameter is not
relevant when
auto-negotiation is
enabled (set to N/A
and cannot be
changed)
HALF – Half duplex operation.
FULL – Full duplex operation.
Default: HALF
Select in accordance with
the capabilities of the
equipment connected to the
same LAN with the
FCD-E1LC.
BRIDGING
Selects the Ethernet
traffic processing
mode
FILTER – The internal bridge of
FCD-E1LC is enabled, and filters
the traffic transferred to the
remote end.
TRANS – The internal bridge of
FCD-E1LC is disabled, and the
Ethernet traffic is transparently
transferred (LAN extender
function).
Default: TRANS
ETH_SPEED
Selects the LAN rate
mode when
auto-negotiation is
disabled.
This parameter is not
relevant when
auto-negotiation is
enabled (set to N/A
and cannot be
changed)
10Mbps – operation at 10 Mbps.
100Mbps – operation at
100 Mbps.
Default: 100Mbps
Select in accordance with
the capabilities of the
equipment connected to the
same LAN with the
FCD-E1LC.
FLOW_CONTROL
Controls the use of
flow control for the
Ethernet port
DISABLED – Flow control is
disabled.
ENABLED – Flow control is
enabled. This selection is possible
only when auto-negotiation is
enabled.
Default: DISABLED
The method used for flow
control depends on the
operating mode:
• Back pressure for the
half-duplex mode
• Sending of
Pause frames
when operating in the
full-duplex mode
DEF DNLOAD
Purpose
Define the inband management communication parameters. Refer to Table D-6
for the parameter description, allowable ranges and configuration guidelines.