Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-19
Use – Ethernet Port
1. To define the parameters of the Ethernet port, type:
DEF CH 2<Enter>
The first row of the Ethernet port parameters data form is displayed. A
typical row is shown below.
This row is similar to that displayed for serial data channels, except that
the CLOCK MODE field is always DCE, CTS is always N/A and
CLOCK_POLARITY is always NORMAL.
MULTIPLIER SPEED FIFO_SIZE CLOCK MODE CTS
CLOCK_POLARITY
64 64 KBPS AUTO DCE N/A
NORMAL
2. Change the desired parameters and then press <Enter> to display the
Ethernet port configuration parameters row.
A typical Ethernet port configuration parameters row is shown below.
AUTO_NEGOTIATION ETHERNET MODE BRIDGING ETH_SPEED
FLOW_CONTROL
ENABLE N/A TRANS N/A
ENABLE
3. Change the desired parameters and then press <Enter> to display the
timeslot assignment parameters row. A typical form is shown below.
MAP_MODE START_TS TS_TYPE
SEQ 1 DATA
4. When done, press <Enter>.
Refer to
Table D-4 for a description of the parameters common to both the
Ethernet port and the serial data channels, and to
Table D-5 for a description of
the specific Ethernet port parameters.
Table D-5. Ethernet Port Configuration Parameters
Parameter Function Values Configuration Guidelines
AUTO_
NEGOTIATION
Controls the use of
auto-negotiation for
the Ethernet port.
Auto-negotiation is
used to
automatically select
the mode providing
the highest possible
traffic handling
capability
ENABLE – Auto-negotiation is
enabled.
DISABLE – Auto-negotiation is
disabled.
Default: ENABLE
Use auto-negotiation
whenever the equipment
connected to the same LAN
supports this capanility