Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-11
 When the desired selection is displayed, press the spacebar to move to
the next field.
The call-out parameters displayed on the first page of the data form, and
their range of values, are explained in
Table D-3 .
3. When done, press <Enter> to display the second page of the call-out
parameters data form. A typical display is shown below.
NEW PRIMARY NUMBER [MAX 16 CHARS] =
4. Enter a new primary directory number and press <Enter>. The directory
number can include up to 16 digits, including the # and the * symbols.
FCD-E1LC displays the new primary directory number you have entered.
CURRENT PRIMARY DIAL COMMNAND = 'primary number'
5. Press <Enter>:
If the ALT_NUM_MODE parameter is NO (no alternate number), FCD-E1LC will
display the time and date, followed by the FCD-E1LC prompt.
If the ALT_NUM_MODE parameter is YES, press <Enter> to see the third page
of the call-out parameters data form, used to enter a new alternate directory
number. A typical display is shown below.
NEW ALTERNATE NUMBER [MAX 16 CHARS] =
6. Enter a new alternate directory number and press <Enter>. The directory
number can include up to 16 digits, including the # and the * symbols.
FCD-E1LC displays the new alternate directory number you have entered.
CURRENT ALTERNATE DIAL COMMAND = 'alternate number'
7. After entering the desired directory number, press <Enter> to end.