Specifications

FCD-E1LC Ver. 1.0 Cable Connections 1
Quick Start Guide
If you are familiar with the FCD-E1LC, use this guide to prepare it for operation,
starting from its factory-default configuration.
1. Preliminary Preparations
At this stage, do not connect any cables to the FCD-E1LC.
Before performing the preliminary preparation procedures described below,
review the safety precautions given in
Section 2.1.
Set all the sections of the rear-panel E1/T1 LOOPBACK switch to OFF.
2. Connection to Power and Grounding
Any interruption of the protective (grounding) conductor (inside or outside the
device) or disconnecting the protective earth terminal can make the device
dangerous. Intentional interruption is prohibited.
AC power should be supplied to the FCD-E1LC through the 5-foot (1.5m)
standard power cable terminated in a standard 3-prong plug.
The connection of the FCD-E1LC to a DC power source is made by means of a
cable terminated in the AC/DC adapter (AD) plug.
The AC power cord plug must be inserted in an outlet provided with a protective
ground (earth) contact, whereas when using DC power it is necessary to ground
the AD grounding terminal. The protective action must not be negated by use of
an extension cord (power cable) without a protective conductor (grounding).
FCD-E1LC does not have a power on/off switch, and therefore it will start
operating as soon as power is applied. It is recommended to use an external
power on/off switch to control the connection of power to the FCD-E1LC. For
example, the circuit breaker used to protect the supply line to the FCD-E1LC may
also serve as the on/off switch.
Caution
Caution