User`s manual

Chapter 5 Performance RADview FCD-IP User’s Manual
5-2 Performing Diagnostic Tests
5.2 Setting the Polling Interval
RADview enables you to set the current statistics polling interval to automate
FCD-IP statistics updates, per assigned elapsed time intervals.

To set the polling interval:
1. Select a Link or Channel.
2. Select Statistics >Physical Layer > Polling Interval…
or
Select Statistics >Physical Layer > SHDSL > Polling Interval…
The Polling Interval dialog box appears (Figure 5-1).
3. Enter the polling interval in seconds and check the Polling Enable checkbox.
4. Click <Set>.
Figure 5-1. Polling Interval
5.3 Performing Diagnostic Tests
RADview enables you to run diagnostic tests.
When configuring TDM (E1/T1) parameters a password is required.

To run diagnostics tests:
1. Select a Link or Channel.
2. Select Diagnostics >Test…
The Testing dialog box appears.
Figure 5-2. Testing
Note Note