User`s manual

Displaying Sanity Check Errors (E1/T1 Link) 4-1

Chapter 4

Fault Management

This chapter discusses how to manage faults for the FCD-IP system.

Managing faults includes the following tasks:

• Displaying Sanity Check Errors (E1/T1 Link)

• Displaying SHDSL Alarms.

4.1 Edit and Agent Views

Certain TDM ports can be displayed in both Edit and Agent Views. Configuration is

performed in the Edit mode. In Agent View, the parameters are Read-Only.



To switch between Edit and Agent views:

1. Select the appropriate Link.

2. Switch to Edit View by doing one of the following:

 Click the Edit/Agent View button on the toolbar

 Select Window > Edit View/Agent View to switch to Edit/Agent View.

4.2 Displaying Sanity Check Errors (E1/T1 Link)

RADview enables you to display the Sanity Check Errors List.

Sanity Check Errors is available only for E1/T1 interfaces (Edit View).



To display the sanity check errors list:

1. Select a Link or Channel.

2. Click the Edit View button on the toolbar

3. Select Fault >Sanity Check Errors…

The system performs a sanity check.

If there are no errors, the following message appears “NO SANITY

ERRORS”.

If there are errors or warnings, the Sanity Check Errors List appears

(Figure 4-1).

Note