User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-36 Configuring Network Parameters
Table 3-23. IP Routing Protocol Parameters (Cont.)
Parameter Possible Values / Remarks
OSPF
Area ID The IP address that identifies the OSPF area.
[…] Opens the Select Area dialog box listing the existing OSPF areas and the behavior
type of each area.
To select an OSPF area, click<…>. Select the desired area from the listing and click
<OK>.
Priority
Hello Interval The interval (in seconds) at which a hello message is transmitted in the area.
Dead Interval The interval (in seconds) after which, if no hello message is transmitted from a unit, it
will be considered “dead”.
Metric
Configuring the IP RIP Mode

To set IP RIP Mode:
1. Select a link in which protocol type is not FR.
2. Select Configuration >Network Parameters > IP RIP…
The IP RIP Mode dialog box appears.
Figure 3-26. IP RIP Mode Dialog Box
Table 3-24. IP RIP Mode Parameters
Parameter Possible Values / Remarks
Interface The selected interface.
For ISDN the parameters below will appear on two tabs: Channel 1 and Channel 2.
Mode RIP 1: Send and receive routing information about IP nets only
RIP 2: Send and receive full routing information including subnets
RIP 1 & RIP 2: Send and receive both RIP 1 (routing information about IP nets only)
and RIP 2 (full routing information including subnets)
No RIP