User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-34 Configuring Network Parameters
3.5 Configuring Network Parameters
RADview enables you to set IP addresses, IP routing protocol and DHCP Relay
parameters for the selected interface or DLCI.
Configuring IP Addresses

To set an IP Address:
1. Select the required interface.
2. Select Configuration >Network Parameters > IP Addresses…
The IP Address Table dialog box appears. The IP Address Table dialog box
varies depending on the selected link or DLCI. The parameters of the
different dialog boxes are provided below.
Figure 3-24. IP Address
Table 3-22. IP Address Parameters
Parameter Possible Values / Remarks
Interface The selected interface.
For ISDN there are two tabs: Channel 1 and Channel 2.
IP Address The WAN/LAN IP Address.
IP Mask The IP Address mask.
Interface The selected interface.
DLCI# Specifies DLCI number.