User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-30 Configuring Protocol Parameters
Table 3-19. FR Parameters
Parameter Possible Values / Remarks
Port Interface The selected interface.
DLCI / Maintenance
Self Learning
Specifies whether device self learns maintenance protocol on FR link and the
existing DLCIs and staus of the existing DLCIs (Up or Down).
On, Off
When Off, maintenance protocol and DLCI must be configured manually.
Maintenance Protocol Specifies maintenance protocol of the FR link.
This parameter is available for configuration only when DLCI / Maintenance Self
Learning is Off.
T1.617/Annex D, Q.933/Annex A, LMI, None
CLLM Status (on/off) Specifies whether or not CLLM frames used for congestion are supported.
Disable, Enable
Polling Interval (Sec) Specifies number of seconds between transmission of two successive status enquiry
frames.
5 - 30
Full Enquiry Interval Specifies number of polling intervals after which a full status request frame is
transmittted.
1 - 255
Error Threshold Specifies number of umacknowledged monitored events allowed in a sliding
monitored event window before link is declared DOWN.
1 - 10
Monitored Events Specifies number of monitored events (status enquiry frames and full status enquiry
frames).
1 - 10
Configuring the DLCI Table

To configure DLCI parameters:
1. Select a Link or Channel.
2. Select Configuration > Protocol Parameters > DLCI…
or
from the FR Parameters dialog box (Figure 3-20) click <DLCI Table…>.
The DLCI Table dialog box appears.