User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Protocol Parameters 3-29
3.4 Configuring Protocol Parameters
RADview enables you to configure parameters for the different protocols.
Table 3-18. Protocol Options per Interface and Link Types
Interface Link Type Protocol
V24 Async SLIP, CSLIP, PPP
V24 Sync HDLC, RFC1490, PPP
V35, V11 Sync HDLC, RFC1490, PPP
ISDN Sync PPP
4W, E1/T1, SHDSL Sync HDLC, RFC1490, PPP
CHANNEL (N × 64)
Sync No protocols over CHANNEL
For IP Routing protocol, see Protocol Type.
Configuring Frame Relay Protocol Parameters

To configure Frame Relay parameters:
1. Select a Link or Channel.
2. Select a port where the Protocol Type (see Protocol Type) has been defined as
FR.
3. Select Configuration > Protocol Parameters…
The FR Parameters dialog box appears.
Figure 3-20. FR Parameters
Note