User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Physical Parameters 3-13
Configuring ISDN Physical Parameters

To configure ISDN physical parameters:
1. Select the ISDN Link.
2. Select Configuration >Physical Parameters…
The ISDN dialog box appears.
3. Click on the desired tab and configure desired parameters.
4. Click <Set>.
Figure 3-8. ISDN Parameters – Interface Tab
Table 3-10. ISDN Parameters – Interface Tab
Parameter Possible Values / Remarks
Interface LINK1, LINK2
ISDN Line Type
Dialup, Leased
ISDN Standard
V1, ETSI, 5ESS, DMS100, National-1, NTT
Enabled when ISDN Line Type=Dialup
Connection Mode
Point to Point, Multi Point
Clock Rate (Kbps)
56, 64