User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-8 Configuring Interface Information
Table 3-6. Interface Information Link Data Tab Parameters for E1/T1 over SHDSL
Parameter Possible Values / Remarks
Interface The selected interface.
State Enable, Disable, Backup (only if there is more than one link)
Backup of Link The combo box listing links in current configuration.
Note: This field is disabled for SUB links
Link Type
Synchronous
Protocol Type
PPP,
RFC1490, HDLC Framing
Routing/Bridging
Bridge, IP Router, IPX Router, IP and IPX Router, IP Brouter, IPX Brouter, IP and IPX
Brouter
IP Transparent
Mode
Disable
, Enable All
Note: This field is not available in the following cases:
• If any of the following interfaces exists on the device:
LINK 3; LAN 2; ISDN; or a non-Channel
X.21(4), V.24(11), RS-530(3), or DB-25(17)
• When the value in the Routing/Bridging field is one of the following:
Bridge, IPX Router, IPX Brouter
• When the selected interface is a Channel
IP Transparent
Default Gateway
Specifies the default gateway IP address used for transparent IP.