User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Interface Information 3-5
Table 3-3. Info Tab Parameters for SHDSL
Parameter Possible Values / Remarks
Interface The selected interface.
Type The type of interface.
SHDSL
Description Description of the selected interface.
Oper Status The operational status of link.
Up, Down
MTU The maximum Transmit Unit for IP fragmentation.
Frames lager than MTUare fragmented into smaller units when sent through the
specified interface
Changing the protocol type from Frame Relay (RFC 1490) to any other protocol will
cause the device to reset.
The following message appears “This operation will cause HW reset of the Device.
Continue?”
Click <OK> to confirm reset.
Table 3-4. Interface Information Link Data Tab Parameters for SHDSL
Parameter Possible Values / Remarks
Interface The selected interface.
State Enable, Disable, Backup (only if there is more than one link)
Backup of Link The combo box listing links in current configuration.
Note: If Link 3 is a SUB link, it is not avalable as a backup link.
Link Type
Synchronous
Protocol Type PPP, RFC1490, HDLC Framing
Routing / Bridging
Bridge, IP Router, IPX Router, IP and IPX Router, IP Brouter, IPX Brouter, IP and IPX
Brouter
IP Transparent
Mode
Disable
, Enable All
Note: This field is not available in the following cases:
• If any of the following interfaces exists on the device:
LINK 3; LAN 2; ISDN; or a non-Channel
X.21(4), V.24(11), RS-530(3), or DB-25(17)
• When the value in the Routing/Bridging field is one of the following:
Bridge, IPX Router, IPX Brouter
When the selected interface is a Channel
IP Transparent
Default Gateway
Specifies the default gateway IP address used for transparent IP.
Note